Selection and use skills of pipe fittings hot melt welding machine

The product models and parameters produced by each manufacturer are different, so when choosing a pipe fitting hot-melt welding machine, you should choose a new automatic pipe fitting hot-melt welding machine that supports manual and barcode dual-use, otherwise you can choose other ranges that will be useful in the process of use Reduced, thereby reducing the efficiency of use and causing unnecessary waste,
During construction, generally when the power source is within 50 meters from the welding machine, it is necessary to use a 2.5mm² input cable. By analogy, the longer the distance, the greater the voltage of the cable used. When the grid voltage does not meet the requirements, it must be used at this time. Generator to support power supply. There are strict requirements when using the pipe fitting heat fusion welding machine. It must be used by professionals and certified personnel. Non-professionals should not approach it to avoid unnecessary danger to the operator.
The control box of the pipe fittings heat fusion welding machine is connected with a pressure sensor and a temperature probe, which can control and adjust the temperature of the heating plate, and can also control the five stages of the welding process: preheating stage, heat absorption stage, conversion stage, welding stage, and cooling stage The time parameter. It is allowed to set and record different pressure and maintenance time at each stage during work, and each working cycle can be automatically recorded and repeated. A new set of welding parameters is selected, and if the actual parameters are out of tolerance, an alarm will appear.
The automatic pipe fitting hot-melt welding machine can realize consistent, reliable and repeatable operation; the system will control, monitor and record the main parameters of each stage in the welding process to judge the condition of each welding joint; the welding machine has a data retrieval storage device and The data download interface can store and download welding data; after milling the end face of the pipe, it can automatically check whether the pipe is firmly clamped; automatically measure the dragging pressure and automatically compensate the dragging force.
The temperature of the hot plate is automatically monitored according to the selected parameters. Only when the temperature of the hot plate is within the set working temperature range, the welding machine can perform welding; all stages after the hot plate is placed on the end faces of the two pipes to be welded (pressurization, crimping, Pressure drop to drag pressure, heat absorption pressure and time, switching: rack opening/hot plate extraction/rack closing, pressurization, pressure holding, cooling) automatically; the microprocessor adopts a closed-loop control system.