Detailed tutorial on how to use manual butt fusion butt welding machine

The heating plate of this hot-melt butt welding machine adopts an independent temperature control system and PTFE surface coating; it adopts a new electric milling method with single and double-sided milling functions; the milling blade is made of high-quality tool steel, double-edged design, It can be used on both sides; the main part of the frame is made of aluminum alloy, which is simple in structure, compact and easy to use; single-person operation is suitable for use in complicated situations.
When using the manual hot-melt butt welding machine, first connect the oil pipe, the electric heating plate connection, and the power cord of the milling cutter; plug in the main power cord, turn on the main power switch and the hydraulic motor switch on the left side of the chassis; set the heating temperature by setting the switch Set to 220°C. Turn on the heat switch.  
Fix the pipes to be connected to both ends of the clamp. It is advisable that the gap between the two pipes can be put into the milling cutter disc. Put on the milling cutter head and mill the butt end of Lyon flat. Note: the milling cutter should be started first, and then the oil cylinder should be started to move forward slowly. It is advisable to adjust the cutting pressure from low to high until the oil cylinder moves slowly. Note: the cutting pressure should not exceed 3Mpa. When continuous cutting occurs, remove the milling cutter head. Straighten the two butt joints by adjusting the tightness of the fixture so that the misalignment is not greater than 10% of the wall thickness.