Knowledge

1. Power supply: responsible for providing stable power input, usually adapting to different mains voltages, and performing corresponding conversion and adjustment. 2. Control unit

1. Optimize the cooling system: Regularly clean the dust and debris on the cooling fan and heat sink to ensure good ventilation. Check whether the cooling fan is operating normally

The recovery time of overload protection and overheating protection of Electrofusion welding machine will be affected by many factors, such as the model, power, heat dissipation co

1. Different triggering reasons: Overload protection is usually triggered when the current or power output of the welding machine exceeds its designed rated value. This may be due

1. Check the cooling system: Clean the dust and debris on the cooling fan to ensure the normal operation of the fan. Check whether the cooling channel is blocked. If there is any b

1. Power failure: including power failure, unstable voltage, poor contact of power plug, etc. 2. Display screen failure: For example, the display screen is not bright, the display

1. Operator qualifications: Operators should be professionally trained and familiar with the operating procedures and safety specifications of the equipment. 2. Work environment in

1. Preparation: The operator sets the required welding parameters on the equipment, such as welding current, voltage, speed, etc. At the same time, the pipe to be welded is sent to

1. Regular cleaning: Clean the inside and outside of the pipe welding machine regularly. Use a clean cloth or brush to remove dust and debris from the welding area. Make sure the e